2005 Leaking Hydro-boost cylinder (leaking hydra-boost)

[Dynomutt]

Anyone know of a rebuild kit for a '05 Hydro-boost cast iron slave cylinder? Mine has just started leaking pretty badly, (approx. 60,000 miles), from the machined mating surface between the two halves of the cast iron slave cylinder. Also, are there any editorials on removing and rebuilding the slave cylinder?

10-26-08
Shortly after this post I found the problem was simply a loose hi-pressure fitting at the top/back of the hydro-boost slave cylinder on the firewall. I had to unbolt the master cylinder and move it forward and down a bit so I could tighten all the fittings, and I could barely get the wrench on the leaking fitting, but I got it tightened, cleaned up the mess, added some power steering fluid, and have been driving for a few weeks now without a leak.

Thanks,

[BillD]

Go here and ask the parts guys at sunrise ford.

http://www.socaps.comshowthread.php?t=5663

[hotstik]

VanCo ( www.vancopbs.com ) might be able to help you. They specialize in the Bosch hydroboost that our trucks use.