Let's see some lifted 2wd F250

[dezzrats]

i would sell these custom beams for 500.00 , paid almost 3000.00 just for the beams...

That's a smoken deal. One of you 2x4 guys should jump on that and just put them away until you are ready to job.

[browntrout]

i would sell these custom beams for 500.00 , paid almost 3000.00 just for the beams...

Did you just bolt these beams up to the stock mounting brackets? Were you just running the stock radius arms as well?

[az350]

i have the modded hangers, beams are heim jointed, i ran camburg one off custom radius arms. Any radius arm will work as long as its built for the extra lift, fabtech etc.. 500 is smokin on these, i only had them on for appx 3 months.. i also will include steering with new ford tie rod ends !

[browntrout]

Here are the few pics I have of my truck. Starting to clean the body up so I can paint it flat black.

[browntrout]

Does this site not let you post photo's directly into your post from site like photobucket?

[az350]

Custom I Beams, hangers, steering with new ford tie rods.. these parts total over 3000.00 barely used. 400.00

[cadillac3_12s]

2004 F250 2wd 6in fabtech intake straight pipe 6.0 diesel

SAM_0131.jpg

[diestwood09]

Custom I Beams, hangers, steering with new ford tie rods.. these parts total over 3000.00 barely used. 400.00

These still available?

I need to replace my old tie rods - might as well upgrade.

[az350]

still got it all, collecting dust in my garage !

[ididntdoit5150]

are these still by chance available, and if so would the setup work on a 2wd 6.4??

[aux9050]

Az350 do you still have those ibeams?